NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
5 minutes before switching the unit back on. increased every time the ON button on the remote control CAUTION: If you need to continuously reset the heater, is pressed. unplug the unit and call Dimplex North America Limited at battery Replacement 1-800-668-6663. To replace the battery:...
(6) screws on the back panel (Figure 4). This will allow the housing to open to access the internal com- ponents. Remove the four (4) screws that secure the heater to the housing. (Figure 5) NOTE: The whole assembly can be opened at this www.dimplex.com...
SWITCH REPLACEMENT point, ensure that there is no strain added to any of the wir- ing within the housing, when the two halves are separated. Tools Required: Philips head screwdriver Carefully remove the heater assembly out of the log Flat head screwdriver grate leaving the wires still connected.
Check wiring connections Defective LED in Log Connect log to another log grate connection to verify if log works. • If log works, wiring defective - Replace Log Grate Assembly • If log does not work, LED defective- replace Logs www.dimplex.com...
Page 9
PROBLEM CAUSE SOLUTION Heater Heater is not turning Off Improper operation Refer to Operation Section Defective Remote Control Receiver Replace Remote Control Receiver. Initialize to Re- mote Control. Heater is not turning On Improper operation Refer to Operation Section Loose wiring Check wiring connections Defective heater assembly Replace heater assembly...
Need help?
Do you have a question about the DLG1106 and is the answer not in the manual?
Questions and answers