Compact Stove Installation; Operation - Dimplex DS3311 Owner's Manual

Brass and Nickel Doors
The brass and nickel doors are hand finished solid castings. Due
to the nature of the manufacturing process, the doors may have
some small imperfections. This is considered normal and adds to the
character of the stove.

Compact Stove Installation

!
NOTE: A 15 Amp, 120 Volt circuit is required. A dedicated circuit
is preferred but not essential in all cases. A dedicated circuit will
be required if, after installation, the circuit breaker trips or fuse
blows on a regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current rating of the
circuit breaker.
WARNING: Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of
fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce
the risk of fire, electric shock or injury to persons, always use a
licensed electrician.
1. Make sure the unit's Main ON/OFF switch is switched OFF (refer to
operating instruction section).
2. Plug the unit into a 15 Amp/120 Volt outlet. If the cord does not
reach, you may use an extension cord rated for a minimum of 1875
Watts.

Operation

To access the controls go to the back of the Stove (Figure 1).
A. Main ON/OFF Switch
The ON/OFF switch supplies power to all unit functions (heat/flame).
3