radio. Reach underneath ECC control module, and push up on locking
button to release ECC control module. Remove ECC control module from
dashboard. Remove cigarette lighter connector. Lift off dashboard. To
install, reverse removal procedure.
DASHBOARD COVER
NOTE:
When adjusting air-mix damper, only the dashboard cover
needs to be removed.
Removal & Installation
1) Remove side defroster cover plate screws. Remove dash
panel vents by rolling vents down and pulling out. Both vents and air
duct on right side must be removed.
2) Remove left and right side speakers. Remove dashboard
cover screws and lift off dashboard cover. To install, reverse removal
procedure. Ensure hook on right side of dashboard cover plate engages
into upper frame section.
DUCT TEMPERATURE SENSOR
Removal & Installation
1) Turn ignition off. Remove radio. Reach under ECC control
module, push up on locking button, and release ECC control module.
Remove ECC control module from dashboard.
2) Remove left and right side sound insulation from center
console. Remove glove box. Remove duct temperature sensor connector
and pull down on duct temperature sensor. To install, reverse removal
procedure.
EVAPORATOR
Removal & Installation
Disconnect negative battery cable. Remove dashboard assembly.
See DASHBOARD. Remove climate control unit. See CLIMATE CONTROL UNIT.
Remove evaporator cover screws and clips. Lift out evaporator. See
Fig. 20. To install, reverse removal procedure.
Fig. 20:
Removing Evaporator
Courtesy of Volvo Cars of North America.
HEATER CORE