Table of Contents
Advertisement
Fig. 18:
Removing Cooling Fan Components
Courtesy of Volvo Cars of North America.
CONDENSER
NOTE:
When replacing condenser, always replace "O" rings and
snap-on connections.
Removal & Installation
1) Disconnect negative battery cable. Discharge A/C system,
using approved refrigerant recovery/recycling equipment. Disconnect
air intake hose. Remove hose connector to fan cover.
2) Remove Electronic Control Units (ECUs) from control unit
box. Disconnect control unit box air intake hoses. Remove inlet hose
connector to fan cover. Disconnect relays from relay casing. Remove 4
screws to disconnect fan cover, and fold cover back towards engine.
Remove relay shelf and spacers. See Fig. 18.
3) Disconnect pipes from condenser. Disconnect high-pressure
sensor connector. Remove high pressure sensor. Disconnect condenser
screws. Lift condenser out.
4) To install, reverse removal procedure. Transfer high-
pressure sensor and rubber gasket to NEW condenser. Lubricate NEW "O"
rings with compressor oil.
DAMPER MOTOR
Removal & Installation
Turn ignition off. Remove soundproofing from center console.
Remove glove compartment. Disconnect connector from damper motor
(located on A/C control unit). Hold catches in on both sides of damper
motor and pull motor straight out. See Fig. 19. To install, reverse
removal procedure.
Hide quick links:
Advertisement
Table of Contents
