Table of Contents
Advertisement
If you removed any expansion boards, replace them
11.
(see "Installing an Expansion Board" in Chapter 5).
Replace the access cover. Reconnect the system power
12.
cables and peripheral devices.
13.
Power on the system.
Run Setup (see Chapter 4, System BIOS and Utilities).
14.
RECOVERING THE BIOS
The following sections describe how to recover the system
BIOS. A recovery diskette is required to recover the BIOS.
See the NECCSD Bulletin Board Service for system BIOS
information.
1.
Turn off the power and unplug the system and any
peripherals.
Turn off the system before you change any jumper
settings.
Remove the access cover (see "Removing the Access
2.
Cover" in Chapter 5).
Locate the Configuration jumper (J8A1) on the system
3.
board (see "Locating the Jumper" in the previous
subsection).
4.
If necessary, remove any installed expansion boards to
access the jumper (see "Removing an Expansion Board"
in Chapter 5).
5.
Remove the jumper block from pins 1-2. We recommend
that you use needle nose pliers to move a jumper.
6-4 Setting System Board Jumpers
!
WARNING
Advertisement
Table of Contents
