Figure 2-17. Icon For A Missing (Removed) Adapter - NEC Express5800/320Ma Manual

Configuring Ethernet PCI Adapters
6. Click Apply to process and save the changes.
7. If you are not physically replacing the Ethernet PCI adapters that you removed,
update the Ethernet address of the team at this time. See
Ethernet Address" on page
If you intend to physically replace the adapters you removed, complete the
following procedure.
To physically replace adapters in a team
1. In systems with hot-pluggable enclosures, if you intend to maintain network
connectivity while removing an enclosure, verify that all active Ethernet PCI
adapters in the enclosure are teamed with adapters in another enclosure. See
"Locating Ethernet PCI Adapters" on page 2-15
Ethernet PCI adapters in the system.
2. Click OK to exit PROSet.
3. Physically remove the Ethernet PCI adapters from the system and install the new
adapters. For more information about removing and replacing adapters, see the
operation and maintenance guide for your system, as listed in
4. Start the PROSet utility (see
5. Remove the entries for the Ethernet PCI adapters that you physically removed from
the system. The entries should have an icon with an X to indicate that these
adapters are missing
For each adapter you want to remove, right-click the adapter entry and select
Remove Adapter. When you are finished, click Apply to process the changes.

Figure 2-17. Icon for a Missing (Removed) Adapter

6. Add the new Ethernet PCI adapters to the team, as
to a Team"
2-30 Express5800/320Ma: PCI Adapter Guide
2-32.
N O T E
If you intend to use the old Ethernet PCI adapters in other
systems, do not install them in other systems until you
reset the Ethernet address of the team (when you reach
step 5 of "Adding Ethernet PCI Adapters to a
(Figure
describes.
to determine the location of
"Starting PROSet" on page
2-17).
"Updating a Team's
Table 1-2.
Team").
2-7).
"Adding Ethernet PCI Adapters