Figure 2-5. Setting The Link Speed And Duplex Mode - NEC Express5800/320Ma Manual

To set the link speed and duplex mode
1. Start the PROSet utility if you have not already done so (see
page 2-7).
2. In the left pane of the Intel(R) PROSet for Wired Connections dialog box, click
an adapter. (Each port on a dual-port Ethernet PCI adapter appears as a separate
PCI adapter in PROSet.) If necessary, expand a team to access its member
adapters.
3. Click the Speed tab.
4. Under Link Speed and Duplex Settings, select the speed and duplex mode
appropriate to the port and to the type of line to which the port is connected.
Figure 2-5 shows how to specify 100 Mbps and full duplex for one of the ports on
a U575 Dual-Port Copper Gigabit Ethernet Adapter.

Figure 2-5. Setting the Link Speed and Duplex Mode

5. Repeat steps 2 through
the link speed and duplex mode.
6. Click Apply to process and preserve the changes. Allow several seconds for
PROSet processing time.
7. In the General tab for each adapter you updated, verify that the link speed and
duplex settings are correct and, if a network cable is attached, that a link is
established (Figure
4 for each Ethernet PCI adapter for which you need to set
2-6).
Configuring Ethernet PCI Adapters
"Starting PROSet" on
Ethernet PCI Adapters 2-17