Creating Ethernet Teams; Figure 2-6. Verifying Link Speed, Duplex Mode, And Link Activity - NEC Express5800/320Ma Manual

Configuring Ethernet PCI Adapters

Figure 2-6. Verifying Link Speed, Duplex Mode, and Link Activity

If necessary, also verify the actual link speed and duplex mode LEDs on the
Ethernet PCI adapters and the remote ports to which they are connected. If the link
speed and duplex mode are incorrect, try removing and replacing the network
cables. If the link speed and duplex mode are still incorrect, verify that your network
equipment supports the link speed and duplex mode that you set.
8. Click OK to exit PROSet.

Creating Ethernet Teams

!
1. Start the PROSet utility if you have not already done so (see
page 2-7).
2. In the Intel(R) PROSet for Wired Connections dialog box, right-click one of the
Ethernet PCI adapters listed, point to Add to Team, and then click Create New
Team.
The Teaming Wizard starts.
3. In the first dialog box of the Teaming Wizard
you want to create (for example, Adapter Fault Tolerance), and then click Next.
Depending on the teaming mode you select, PROSet might display another dialog
box with information about the restrictions for that mode. Click Next to continue.
2-18 Express5800/320Ma: PCI Adapter Guide
C A U T I O N
Creating an Ethernet team disrupts the network traffic
over all Ethernet PCI adapters in the team.
"Starting PROSet" on
(Figure 2-7), select the type of team