Access VIRUS|POWERCORE User's Reference Manual page 104

CONTROL CHANGE MESSAGE (ONLY PAGE A)
Byte Meaning
Bc Status byte
nn Parameter Number 0..127
vv Parameter Value
The Control Change messages are defined as Performance Controller (e.g. Modulation Wheel or
Hold Pedal) or Sound Parameters (e.g. Cutoff or Patch Volume). The Performance Controllers are
not stored with a Single-Sound. If more than one Multi Part is set to the same MIDI channel, all Parts
on this MIDI channel receive the same Performance Controllers. The Sound Parameters are stored
with a Single Sound. If more than one Multi Part is set to the same MIDI channel, the Sound Param-
eter is receiced only by the Multi Part with the lowest part number.
Example: B0,21,40 Set oscillator balance (21 hex = 33 dec) on MIDI channel 1 to the middle position
(40 hex =64 dec).
POLYPHONIC PRESSURE MESSAGE (ONLY PAGE B)
Byte Meaning
Ac Status byte
nn Parameter Number 0..127
vv Parameter Value 0..127
Example: A2,07,25 Control LFO3 Rate on MIDI channel 3 (!).
104
Remark
c=MIDI channel
see parameter list Page A)
0..127 see parameter list Page A)
Remark
c=MIDI channel
see parameter list Page B
see parameter list Page B