Self-Test Program - TC Electronic Finalizer User Manual

SELF TEST
PRESS ONE OF THE 3 BYPASS KEYS, WHILE POWER-
ING UP, TO ACCESS THE SELF-TEST AND SELECT
»RUN TEST PROGRAM«
Turn the ADJUST Wheel to scroll through self tests
Key test
Select Key test by pressing OK.
The keys must be pressed in the order they are requested by the
Finalizer to pass the test.
Press OK key again to exit test.
Adjust Wheel test
Select Adjust Wheel test by pressing OK
Turn the Adjust Wheel to 30 and back to 0 to pass test.
Press OK key again to exit test.
LED test
Select Led test by pressing OK
Turn Adjust Wheel to test the LEDs. The test is "ok" when all
LEDs are lit.
Press OK key again to exit test.
Display test
Select Display test by pressing OK
Press OK to check that all pixels are lit. Press any key to leave
the pixel test.
Press OK key again to exit test.
Analog I/O test
Select Analog I/O test by pressing OK
Connect an analog output to the analog input, which has to be
tested and press OK.
Use a balanced cable.
PPM must show -12 dB to pass test.
Press OK key again to exit test.
Digital I/O test
Select Digital I/O test by pressing OK
Connect a digital output to the digital input, which has to be test-
ed and press OK.
The AES/EBU output can also be connected to the S/PDIF input
and vice versa.
PPM must show 0 dB to pass test.
Press OK key again to exit test.
40
MIDI I/O test
Select MIDI I/O test by pressing OK
Connect MIDI out to MIDI In.
Prg. change 1-128 is send out on MIDI thru. Connect this socket
to a MIDI compatible device and confirm the Prg. changes.
Press OK key again to exit test.
Pedal test
Select Pedal test by pressing OK.
Connect a momentary pedal to the pedal socket.
When pressing the pedal, the result should be OK.
When released, the result should be NOT OK.
Press OK key again to exit test.
PC Card test
Select PC Card test by pressing OK
Insert PC Card. Note that all data on the PC Card will be
destroyed.
Press OK to test.
Result reads:
Low battery - Time to change battery in your PC Card.
Not Ok - Try the test using another PCMCIA card.
Press OK key again to exit test.
Battery test
Select Battery test by pressing OK
Confirm that result is OK.
Press OK key again to exit test.
System test
Select System test by pressing OK
Confirm that result is OK.
Result reads:
EEPROM Not OK - The unit will most likely work ok, the mes-
sage is for service matters only.
DSP Not OK - Contact your local dealer.
Press OK key again to exit test.
Power Off - On to start standard software.