Table of Contents
Advertisement
16
− Troubleshooting
Power does not turn on
ª
Make sure that the power plug is firmly inserted.
Media is not detected
ª
•
Make sure that the CF card is firmly inserted.
•
Make sure that the CD is not scratched or dirty
Can't play back
ª
•
In the case of a WAV file, make sure that the file is
of a sampling frequency (44.1 kHz or 48 kHz) and
bit depth (16-bit) supported by the SS-CDR1. In
the case of an MP3 file, make sure that the file is
of a bit rate supported by the SS-CDR1.
•
Make sure that the CD is not scratched or dirty
No sound
ª
Check the SS-CDR1's connections to your monitor
system. Also check the volume of your amp.
Can't record
ª
•
Check the connections once again.
•
Adjust the recording level.
A setting you changed is not remembered
ª
The SS-CDR1 backs-up the settings when you change
them. This backup may fail if you turn off the power at
an inappropriate time, so do not turn off the power
immediately after changing a setting.
Noise is heard
ª
Check whether a connection cable might have a bad
connection.
When editing a name, the display indicates
ª
Name Full
Due to limitations of the system, the number of charac-
ters in a file name and folder name is limited to 255
characters (single-byte). Since the full path within the
folder finder is limited to 255 characters, the maximum
name length for a file or folder that is inside a sub-fold-
er will be reduced by the number of characters used by
any folders above it and any separator characters.
82
TASCAM SS-CDR1
Advertisement
Table of Contents
