Table of Contents
Advertisement
6 − Recording
Sync Record operation
When you put the SS-CDR1 in record-ready condition with
the Sync Record function on, recording will automatically
start or stop according to the level of the input source.
When a signal higher than the sync level is input,
•
recording will begin automatically.
However, recording will not begin even if input is
detected unless there has been at least one second in
which the signal was below the sync level after entering
the record-ready state.
Level
Start of recording
SYNC LEVEL
NOTE
The above explanation is for the case when the
DELAY setting is "0" (the default setting). By changing
the DELAY setting, you can change the "record start"
point.
While recording, if the input signal stays below the sync
level for the duration specified by STOP TIME (default:
5 seconds), the SS-CDR1 will automatically switch to
the record-ready condition.
Level
SYNC LEVEL
NOTE
If you set the STOP TIME to
state will not be entered even though the input signal
continuingly falls below the sync level.
To defeat Sync Record, press the remote's
46
TASCAM SS-CDR1
Time
REC ready
STOP TIME
Time
, the record-pause
I NF
key.
SYNC REC
When the sync level is too high:
•
If the sync level setting is too high, you may have prob-
lems such as failing to capture the beginning of a song
that begins with a low volume.
Level
This part of the track
may not be recorded
SYNC LEVEL
If the sync level is too low:
•
Sync recording will not begin if the source you're
recording has a high noise level, so that the sync level is
exceeded immediately when you enter the record-ready
state.
Level
SYNC LEVEL
Noise is higher
than threshold
Recording starts
Time
Start of track is not registered
Time
Advertisement
Table of Contents
