Setup For Windows 95/98/Me/2000; Step 1: Prepare Network Information - Socket Low Power Ethernet Card User Manual

4 | Setup for Windows 95/98/Me/2000

This chapter explains how to set up the LP-E on a notebook computer
running Windows 95 v4.00.905B, 98, 98 Second Edition, Me or 2000.
Setup Summary

STEP 1: Prepare network information.

STEP 2: Insert the installation CD.
STEP 3: Connect to a LAN port.
STEP 4: Insert the card.
STEP 5: If needed, install the software.
STEP 6: Enter network settings.
STEP 1: Prepare Network Information
Contact your network administrator for the information below.
For a text-only form that you can email to your network
administrator, go to the Docs folder on the installation CD or visit:
www.socketcom.com/support/support_ethernet.asp
Does the network support DHCP (Dynamic Host Configuration Protocol)?
YES. If Yes, then STOP. You do NOT need any IP addresses.
NO. If No, then please specify any applicable IP addresses (you may
only need some listed below):
Mobile Computer IP address: _____ . _____ . _____ . _____
Subnet Mask: _____ . _____ . _____ . _____
Default Gateway: _____ . _____ . _____ . _____
Primary DNS: _____ . _____ . _____ . _____
Secondary DNS: _____ . _____ . _____ . _____
Primary WINS*: _____ . _____ . _____ . _____
Secondary WINS: _____ . _____ . _____ . _____
*Remote ActiveSync only: If your server does NOT have WINS services
enabled, use the IP address of your host PC instead of a Primary WINS
address.
26