Property Ksktscanpropidsoftscanstatus - Socket ScanAPI Reference Manual

Socket ScanAPI Reference
DBGSKT_TXW
DBGSKT_TXE
The Get property can be used to retrieve a particular monitor mode. The property
must have its byte value set to one of the monitor modes. The Get complete contains
the actual level in its Ulong value.
The Set property can be used to change the monitor mode level. An array of 5 bytes
should be initialized with the first byte set to the particular monitor mode, and the 4
remaining bytes should contain the new 32 bit value in big-endian format.
Parameter type
Get
Byte
Version
ScanAPI Interface Version

13.8 Property kSktScanPropIdSoftScanStatus

This property enables or disables the SoftScan feature. The SoftScan feature uses the
device camera to scan a barcode. Some devices might not meet all of the
requirements for such an operation. When the SoftScan is enabled and the
requirements are all met for scanning a barcode using the camera, then a new
device arrival will be generated with the necessary information for opening a
SoftScan scanner.
ScanAPI generates a device removal when the SoftScan scanner is disabled by using
this same property to turn this feature off.
The possible values for the byte data field are described in the following table:
Name
kSktScanEnableSoftScan
kSktScanDisableSoftScan
© 2013 Socket Mobile, Inc.
0x00000402
0x00000404
Get Complete
Ulong
path
Warnings from the
transmit path
Errors from the transmit
path
Set
Array
1.0.0 or higher
Description
Enables the SoftScan feature when used
in the Set operation, or the SoftScan
feature is enabled when retrieved in the
Get Complete response.
Disables the SoftScan feature when used
in the Set operation or the SoftScan
feature is disabled when retrieved in the
Get Complete response.
Set Complete
None
81/152