Socket ScanAPI Reference Manual page 103

Socket ScanAPI Reference
off time
Connected auto off
time
NOTE:
On the 7 series, the Set operation cannot set the trigger lockout timer at the same
time as the connected power off timer or disconnected power off timer. If the set
operation has the timer mask set to kSktScanTimerTriggerAutoLockTimeout and
any of the other values, the result will always fail with an invalid parameter error.
For the 7x series, there is no such restriction but it is recommended to update the
Trigger Lock out Timeout separately so the operation will always succeed whatever
device series is used.
Additionally, the highest trigger lockout timer value supported by the 7 series 1D
scanners is 255, or 63.75 seconds. Any higher value will generate an invalid
parameter error.
C/C++:
The constant definition can be found in the SktScanPropIds.h file.
Java:
The constant definition can be found in
com.SocketMobile.ScanAPI.ISktScanProperty.values.timers
C#:
The constant definition can be found in
ScanAPI.ISktScanProperty.values.timers.
Objective C:
The constant definition can be found in the SktScanPropIds.h file.
Parameter type
Get
None
Version
ScanAPI Interface Version
© 2013 Socket Mobile, Inc.
2 bytes
Get Complete
Array
when no activity is detected and there is
no connection to any host.
Time in minutes to leave power on
when no activity is detected while
connected to a host.
Set
Array
1.0.0 or higher
Set Complete
None
103/152