Removing Jumper Cables - Ford Vehicle Owner's Manual

Removing jumper cables

1. Always remove the jumper cables in the
reverse order. Remove the negative ( ) end
of the jumper cable from the metallic surface
on the engine or frame of the disabled
vehicle.
2. Remove the negative ( ) cable from the
booster battery.
3. Remove the positive (+) cable from the
booster battery.
4. Remove the other end of the positive (+)
cable from the discharged battery.
After the vehicle is started, let it idle for a while
to let the engine "relearn" its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
You may need to use a battery charger to fully
recharge the battery.
If you need to replace your battery, see Battery
in the Servicing Your Vehicle chapter.
257