Table of Contents
Advertisement
The fitting bracket (1) is located between the carrier rail (2) and
the support upright (3). Please note that the guide nubs of the
fitting bracket must fit into a hole in the support upright next to
the spring nut.
7
Secure the two carrier rails in the rack at the left and right support
uprights (4).
Mounting/removing the server in the rack
To finish setting up the Fortress 1120 server in rack mount fashion,
mount the prepared server into the assembled rack model.
To mount the server in the rack
1
Lift the server onto the two carrier rails.
2
To mount the server into the rack:
a
Slide the server into the rack (1).
b
Secure the server in the rack using the two knurled screws (2)
Refer to the figure on the next page.
45
Advertisement
Table of Contents
