Connecting The Server To The Mains - AOpen Fortress 1120 User Manual

22
2 Connect the power cable of the monitor to a grounded mains
outlet of the in-house mains and/or into the mains socket strip of
the rack.
Note: The rated current for the monitor can be found on the
technical data label on the monitor or in the operating manual for
the monitor.
Connecting options
Aside from the monitor, other peripheral devices (e.g., mouse,
keyboard) can also be connected to the server. Some of these devices
may require special driver software; if this is the case you will need to
refer to the documentation that accompanies that device.
To connect a peripheral device, plug in the device's data cable to its
corresponding port on the server. Refer to "Rear panel" on page 9 for
a list of standard ports available for Fortress 1120.

Connecting the server to the mains

The server has a fixed power supply unit.
The server automatically adjusts to a mains voltage between 100 V to
127 V and/or 200 V to 240 V. The server may be place in operation only,
if the mains voltage range set on the server corresponds to the local
mains voltage.
To connect the server to the mains
1 Connect the insulated connector of the power cable to power
supply unit of the server.
2 System setup