Setting Up The Stand-Alone Model - AOpen Fortress 1120 User Manual

20
• Fortress 1120 User's guide
• Fortress 1120 Driver CD
• Fortress 1120 Anti-virus CD
3 Check the contents of the package for visible transport damage.
4 Check whether the delivery agrees with the details in the delivery
note.
The identification rating plate is located on the front area on the
server.
If you find transport damage or inconsistencies between the
contents of the package and the delivery note, inform your
supplier immediately!
5 It is recommended not to throw away the original packaging
material as it may be required for transportation at some later
date.

Setting up the stand-alone model

Position the stand-alone model at the intended location.
Note the following:
• The device must be protected from direct sunlight.
• The required minimum distances for operation and maintenance
areas must be adhered to.
• In order to connect other devices (e. g.: storage subsystem) the
rear of the server must be accessible.
• The mains plug must be accessible easily and safely.
• There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation.
• The delivered rubber feet must be glued on the bottom of the
device. You find corresponding square reliefs at the bottom of the
device.
2 System setup