Table of Contents
Advertisement
H
ardware Installation
This section will assist you quickly
before ha
ndling components. Electrostatic discharge may damage your system co
CPU Processor Inst
This mainboard
supports Intel
system, we suggest
you to visit the Intel website and review the processor installation
http://www.intel.
com
CPU So
cket 478 Configuration Steps:
Locate the CPU socket
on your mainboard and nudge the lever away from th
lever o a 90-degree angle.
t
On the socket, locate the corner that has the pin-1 receptor. This corner will be near the end of the
lever n the socket. Match the dot on the CPU with the pin-1 receptor on the socket and lower the
o
CPU onto the socket. The bottom of the CPU should be flush with the face of the socket.
Lower th
e lever
back into position. This will lock dow
Smear thermal grease on top of the CPU. Lower the CPU fan onto the CPU and use the clasps on the
fan to attach it to the socket. Finally, extend the power cable from the fan and insert it onto the
JCFAN1 header.
Attention: Before starting the system
Please check the installation completely before starting the system.
Verify that the heatsink is properly installed and make sure the CPU
fan is working. Overheating can damage the CPU and other
sensitive components.
in installing your system hardware. Wear a wrist ground strap
allation
®
®
Pentium
4 processors using a Socket 478.
Pin1 Receptor
n the CPU.
6
mponents.
Before building your
procedures.
e socket. Then lift
the
Dot
until it
snaps
Advertisement
Table of Contents
