Mounting Procedure - Aiphone JM-4HD Installation & Operation Manual

Mounting procedure

<Back wiring>
1 Fasten the mounting
bracket to the wall.
The unit
3 Mount the unit on the
mounting bracket.
2
Connect the CAT5e cables to the unit.
Opening/closing the terminal cover
To open:
Slide the cover to the right until it clicks, and then open.
To close:
Close the cover, and then slide it to the left until it
clicks.
* Make sure the cover is locked.
<Surface wiring>
When the wiring is not coming through the wall, the cable and wires can be routed through the top or bottom of the cable inlet.
Remove cable inlet plate on the upper part of the unit to allow passage of the wiring into the unit.
Cable inlet plate
3-gang box
Mounting bracket
(pre-attached by factory)
Mounting screw × 4 (included)
CAT5e cable
Close
CAT5e cable
Wood mounting screw × 4
(included)
The unit
83.5mm (3-5/16")
Open
Terminal cover
92mm (3-5/8")
Mounting bracket
(pre-attached by factory)
83.5mm (3-5/16")
9