Mounting Procedure - Aiphone JPW-BA Installation Manual

Mounting procedure

■ JP-4MED
<Back wiring>
The unit
3 Mount the unit on the
mounting bracket.
2 Connect the CAT5e cable and wires to the unit.
How to connect or disconnect wires
• Insert the wire into one of the coupling terminals.
• To ensure that the wire will not bend, press the
release button while inserting into terminal.
Release
button
14
1 Fasten the mounting
bracket to the wall.
Wires
Mounting screw × 4 (not included)
CAT5e cable
8mm
(3/8")
3-gang box
Mounting bracket
(pre-attached by factory)
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
Opening/closing the terminal cover
To open:
Slide the cover to the right until it clicks, and then open.
To close:
Close the cover, and then slide it to the left until it clicks.
Make sure the cover is locked.
*
Close
Open
83.5mm (3-5/16")
Terminal cover