Designate Residential Station(S) That Receive A Call From This Station [Room Station Call Settings]; Setting The Microphone On/Off For A Call From A Residential Station [Talk] - [Privacy Mode]; Setting For Indoor Monitoring [Monitor] - [Room Monitor] - Aiphone JM-4HD Installation & Operation Manual

■ Designate residential station(s) that receive a
call from this station [ROOM STATION CALL
SETTINGS]
You can set whether or not the other residential stations receive
a call (all call or single call) from this station. The setting can
be made for each station. A station set to "DISABLE" will not
receive a call from this station.
1
From HOME window, touch
ROOM STATION CALL SETTINGS .
The PIN entry window is displayed.
2 Enter the 4-digit PIN by using the touchscreen, and
then touch ENTER .
"ID 1" to "ID 8" (other than this station) are displayed.
• "ID1" shows the master station.
• "ID2" shows the sub master station whose ID switch is
set to "2". (The same applies to "ID3" to "ID8".)
The ID number of this station is not displayed.
*
If a wrong PIN has been entered, an error message
*
is displayed. Enter correct PIN. (See page 15 for PIN
settings).
3
To change the setting for "ID2", select "ENABLE" or
"DISABLE".
ENABLE .....Allows the station to receive a call from this
station.
DISABLE ....Does not allow the station to receive a call
from this station.
4 Repeat for other stations.
" " or " " to scroll between ID numbers.
* Use
5
When the setting has fi nished, touch
16
SETTINGS → CALL →
ENTER .
Setting the microphone on/off for a
call from a residential station [TALK] -
[PRIVACY MODE]
This setting enables or disables the PRIVACY MODE.
When receiving a call from a residential station individually;
• When set to "ENABLE", privacy mode is set. In this state, a
caller cannot hear audio from this station.
• When set to "DISABLE", audio can be heard from this station
allowing for 2-way communication.
1
From HOME window, touch
2
Touch PRIVACY MODE and select "ENABLE" or
"DISABLE".
3
When the setting has fi nished, touch
Setting for indoor monitoring
[MONITOR] - [ROOM MONITOR]
When set to "ENABLE", this station can be monitored by the
other residential stations. When set to "DISABLE", this station
cannot be monitored by other stations.
1
From HOME window, touch
MONITOR .
2
Touch ROOM MONITOR and select "ENABLE" or
"DISABLE".
3
When the setting has fi nished, touch
TALK .
SETTINGS →
ENTER .
SETTINGS →
ENTER .