Honeywell T775U Series 2000 Installation Instructions Manual page 20

T775U SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLER
SETUP
OUTPUTS
MOD 1
RESET
Fig. 42. Setup - Outputs - Mod Out - Reset.
SETUP
OUTPUTS
MOD 1
HIDE
Fig. 43. Setup - Outputs - Mod 1/2- Hide.
Fig. 44. Setup - Outputs - Mod Out - Exit.
62-0255—07
SETUP
1.3.1.6. RESET
OUTPUTS
MOD 1
This selection enables the controller's Reset function, and
RESET
allows each output to be individually programmed for
YES-BOILER
Reset or No Reset.
YES-OTHER
NO
IMPORTANT
USE
RESET
The RESET choice is offered for all outputs in setup
FOR
MOD1
mode, and you can set any or all of them for Reset=YES
M24605
or Reset=NO. The default is Reset=NO.
For the remaining outputs, if Reset=YES, then these
outputs use the reset curve programmed for the first
output.
1. From the Mod menu, use the
highlight RESET.
2. Use the
value.
3. Press the
return to the Mod menu.
SETUP
1.3.1.7. Hide
OUTPUTS
MOD 1
The Hide option is used to prevent the MOD 1 and MOD 2
HIDE
outputs from displaying on the Home screen.
YES
NO
1. From the Mod menu, use the
highlight HIDE.
2. Use the
3. Press the
return to the MOD menu.
HIDE MOD 1 ON
NOTE: The MOD1 and MOD2 outputs are still active
HOME SCREEN
M28656
1.3.1.7. Exit Modulating Outputs Setup
SETUP
OUTPUTS
Press the
MOD 1
button) to exit the Mod menu and return to the Outputs
TYPE
menu.
MIN OUT %
INTEGRAL
To configure the second modulating output, go to "1.3.1.
DERIVATIV
SCHEDULE
Setting up the Modulating Outputs" on page 18.
EXIT
When you finish setting up the two modulating outputs,
continue with "1.3.2. NBR OF RELAYS".
M24606
20
To use the Reset function of the controller, the
first modulating output (MOD1) must be set for
Reset here.
and
and buttons to highlight the desired
Default: NO
button to accept the selection and
and
and buttons to highlight YES or NO.
Default: YES
button to accept the selection and
even when hidden from the Home screen.
button (or highlight EXIT and press the
buttons to
buttons to