Table of Contents
Advertisement
3 Form Feed Time Out
It is possible to set the maximum amount of time that the printer will wait to receive
data from the computer. If the printer does not receive any data from the computer
within the amount of time specified here, printing will be cancelled.
Press the "–" or "+" key to select either "30 SEC.", "60 SEC.", "120 SEC.", "180 SEC.",
"240 SEC." or "300 SEC.".
* The factory default setting is "30 SEC."
4 Parallel Interface
Both bi-directional and high-speed modes are supported.
Select the desired mode from "AUTO", "NIBBLE HIGH", "NORMAL" and "HIGH-
SPEED" using the "–" key or "+" key.
* By default, "AUTO" is selected.
* If the page contained unnecessary pages or unknown character was printed out,
please change the setting and print again.
5 Page Protect
A print overrun error may occur in case of complex print data. In this case, select
"ON" to allow printing of such data. If "AUTO" is selected, printing speed will drop
slightly.
"AUTO" or "ON" can be selected by using the "–" key or "+" key.
* By default, "AUTO" is selected.
* For detailed on error messages, refer to "7.When This Message is Displayed...".
6 Emulation
Used to select the printer language. To switch to another emulation mode, press the
Change key.
* Emulation (Network) is displayed only if the network board is installed.
Open the screen for emulation setting.
1
Press the "–" key or "+" key to display a list of the available emulation modes, then
select the desired one.
* By default, "PCL 6" is selected.
(The Print KPDL Errors option is displayed only when KPDL or KPDL (AUTO) is
selected. (for overseas version only).)
"ON" or "OFF" can be selected by using the "–" key or "+" key.
6. Printer Configuration
17
Advertisement
Table of Contents
