Olivetti d-Copia 42 Operation Manual page 20

4 Printing when the management function is on
If the printer management function has been set to be effective on the printer, make
the following settings on the PC and print them.
* For details of how to set the printer management function on the printer, refer to the
printer's operation manual.
After the driver is installed, click the driver icon with the right button of the mouse, to
1
display the properties screen.
In the properties screen, click the JOB tab, set the management code to ON, then
2
enter the specified management code. Printing will be enabled, and the number of
copies will be added to those for each department. For details, refer to the operation
manual of the printer and online manual.
* The above procedure varies slightly with the type of driver installed.
* The management code is a secret number provided to enable certain settings
assigned to the corresponding department. This is not a network management
secret number.
If you are using a driver other than the PCL driver, the management ID code must be
selected from a range of 0000 to 0030 or 0000000 to 0000030. Management setting
cannot be made with any other ID code.
Make sure that the management ID code set on the printer is also within this range.
* The screen shown on the right is for the printer driver for Windows NT.
Restriction on the manegement ID code
* Even if an attempt is made to send data directly using a DOS command (e.g.
COPY command), i.e. not via the printer driver, it will not be output.
6. Printer Configuration
21