Table of Contents
Advertisement
Use the numeric keys to enter "4200" (the network management code).
3
* If the correct code is entered, the network setting screen will appear.
* This 4-digit code can be changed. Refer to step 6 and subsequent steps.
Default codes:
4200 for the printers that can copy 42 pages per minute
5200 for the printers that can copy 52 pages per minute
The currently registered IP address, Subnet Mask and Gateway address will all be
4
displayed. To change an address, press the appropriate "CHANGE" key to display the
corresponding setting screen.
* To change the network management code, proceed to step 6.
Note: It is not possible to register or change more than one of the addresses (IP
address, Subnet Mask, Gateway address) by a single operation at the same time.
* Since DHCP has been set to "ON" by default, the changes made to the addresses
will not be effective. For details, refer to "DHCP".
The address will be separated into four blocks – each consisting of three numbers.
5
Press on the block to be changed and then use the numeric keys to enter the desired
number. If the entered numbers are correct, press the "ENTER #" key. Once the com-
plete address is entered as desired, press the "END" key.
* The illustration on the right shows the screen used for entering the IP address.
* After each address has been set, make sure that DHCP is set to "OFF", then turn
the power to the printer OFF, then ON again. The entered addresses will be effec-
tive when the printer is started up.
To change the network management code, press the " " key.
6
The network management code change screen will appear.
* If you do not want to change the code, press the "END" key and the message
display will return to the off-line screen.
To change the displayed code, press the "PAUSE" key and then use the numeric keys
7
to enter the desired 4-digit network management code.
* It is recommended that you make some sort of notation of the new code as, if it is
forgotten, it will not be possible to verify or make changes to the network settings.
* A copy speed of 42 copies per minute.
6. Printer Configuration
19
Advertisement
Table of Contents
