Section 4 Network Turnup Procedure
1.
INTRODUCTION
This section discusses TRACER 6000 Series split system installation.
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate the equipment.
2.
TOOLS REQUIRED
The tools required for TRACER 6000 Series split system installation are:
•
VT100 terminal or PC with terminal emulation software
•
RS-232 (DB-9 male for TRACER 6200) cable for connecting to terminal
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.
3.
UNPACK AND INSPECT THE SYSTEM
This system MUST be installed by qualified service personnel in a Restricted Access
Location.
Each TRACER 6000 Series split system is shipped in its own cardboard shipping carton. Open each carton
carefully and avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier; then contact ADTRAN Customer Service (see Warranty,
Customer Service, Product Support Information, and Training information in the front of this manual).
Contents of Shipment
Your TRACER 6200 IDU shipment includes the following items:
•
TRACER 6200 IDU
•
Rackmount brackets
•
Accessory bag that includes:
RJ-45 to DB-9 adapter (for connection to the
6-foot silver satin cable (for connection to the
Alarm contact connector (3-position terminal block)
Power connector (2-position terminal block)
Extra fuse
•
TRACER 6000 Series Split System Documentation CD
46
TRACER 6000 Series Split System Manual
AUX RS232
AUX RS232
Copyright © 2005 ADTRAN, Inc.
port)
port)
612806320L1-1B