Table of Contents
Advertisement
Preparation/SetUp (continued)
Setting the IP address of the projector
Before setting the IP address, check that the projector has been LAN-networked and turn on the main power of
the projector.
•
When using multiple projectors, connect and confi gure them one by one. If you turn on the powers of the
projectors that are connected but not yet confi gured at the same time, they may not be recognized.
Start the Projector-Control Device Installer.
1
•
Select [Start] - [All Programs] - [Projector] -
[Projector-Control Device Installer] (in the case of
®
Windows
XP).
Click the Search button.
2
•
Projector is recognized.
(Note)
When projector isn't recognized, check the following.
•
The fi rewall function has been disabled. (When it
has been enabled, search may not be conducted.)
•
The personal computer and the projector are on
the same network. (For preventing unauthorized
access.)
•
More than one Projector-Control Device Installer
isn't running.
•
The network adapter being used is selected by
the Option setting of the Tool menu.
•
"STANDBY MODE" of the projector is set to
"STANDARD."
Select a projector by clicking the line showing the
3
projector and click the Assign IP button.
The Assign IP Address screen appears.
4
•
For automatic IP address setting by the DHCP server, go to page 6. For IP address setting without using the
DHCP server, go to page 7.
EN-5
Click here
Advertisement
Table of Contents
