Appendix 2 - Rx Configuration Utility; Rx System Configuration Page - ADDER AdderLink Infinity User Manual

Appendix 2 - RX configuration utility

This section covers the browser-based configuration utility for the Infinity RX
(receiver) unit. The RX utility has five pages, titled as follows:
• System Configuration - Contains various important options,
• Firmware Upgrade - Handles the updating of internal software,
System Messages
• - Options for handling status messages from the unit,
Reboot
• - Cold restart and factory reset options,
About
• - Version details and support information.

RX System Configuration page

This page allows you to set the IP address and netmask for the unit, determine
which of its data streams should be enabled and also configure multicast
operation settings.
See next page for lower half of this screen.
To get here
1 If not already connected, temporarily
computer via a network.
2 Run a web browser and enter the IP address of the Infinity RX unit.
Default: http://9.8..
If the address is unknown, either use the
utility
to discover it, or perform a
3 Click the System Configuration link.
Important Information
See
System IP Address
Enter the IP address that you wish to use for this receiver unit.
The default address is: 192.168.16.127.
System Netmask
Enter the netmask that you wish to use for this receiver unit.
The default netmask is: 255.255.255.0.
Gateway
Necessary only when the TX units is placed on a different network.
Identify unit
Click to flash the front panel indicators (useful when numerous units are mounted together).
Enable Video RX
When ticked, the RX will request video (the similar option at the TX unit must also be ticked).
Enable Audio TX/RX
When ticked, the RX will use audio on condition that the similar option is ticked at the TX unit.
Enable USB TX/RX
When ticked, the RX will use USB on condition that the similar option is ticked at the TX unit.
Enable OSD Alerts
When ticked, the RX unit will show status messages on the attached monitor display.
Audio Input Type
Choose 'line' for stereo line input, 'mic' for mono microphone or 'mic boost' for a mono
microphone that requires extra gain (+20dB).
Update Now
Click to save your changes and, where necessary, communicate those changes to other units.
connect the Infinity unit and a
Start-of-Day configuration
manual factory reset.
on page 2.