Safety Instructions For Installation - Miele KM 2256 Operating And Installation Manual

Safety instructions for installation

This appliance must be installed and
connected to services in
accordance with local and national
safety and building regulations.
To avoid the risk of damage to the
appliance fit wall units and extractor
hood before installing it.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
An electric fryer must not be
installed directly next to a gas hob, as
the gas flames could ignite the fat in the
fryer. It is essential to maintain a
distance of at least 300 mm between
these two appliances.
~
A gas hob must not be installed
above a fridge, fridge freezer, freezer,
dishwasher, washing machine or
tumble dryer.
~
Ensure that the gas pipe and
electrical cable are installed in such a
way that they do not touch any parts of
the appliance which become hot. This
could cause damage.
34
~
The electrical cable and any flexible
gas connection pipe must be installed
in such a way so that they do not come
into contact with any moving kitchen
parts (e.g. a drawer), and cannot
become trapped.
~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop.
All dimensions in this instruction booklet
are given in mm.
Installation area
The room where the gas hob is to be
installed must have
– A minimum capacity of 25.2 m
– At least one externally-opening door
or window
– An extractor hood or a controlled
ventilation system (not recirculation),
which has a minimum capacity of
3
189 m /h
– suitable air inlets.
3