Miele H 370-2 Operating Instructions Manual page 63

Before cleaning the catalytic panels
using high temperatures, make sure
that all PerfectClean surfaces have
been cleaned as previously de-
scribed. Otherwise, the high temper-
atures can cause deposits to be-
come baked on to the PerfectClean
surfaces and become impossible to
remove.
If, after manual cleaning, the oven is
still heavily soiled, heating it to a high
temperature will help remove further
soiling caused by oil and grease
splashes from the catalytic surfaces.
Note that deposits of spices, syrups
and similar substances are not
removed by this process. These should
be removed while fresh by hand with a
mild solution of hot water and washing
up liquid applied with a soft brush.
^ Take all accessories out of the oven.
^ Turn the oven selector to
Fan heat D.
^ Turn the temperature selector to the
highest setting.
^ Run the oven for approx. 1 hour. The
length of time will depend on the
level of soiling.
It is a good idea to set the finish time for
the process using the timer. This way
you will not forget to switch the oven off
at the end.
Any remaining soiling will gradually dis-
appear with each subsequent use of
the oven at high temperatures.
Should the catalytic enamelling on
the back panel, the side liners or the
roof liner become ineffective through
improper use or heavy soiling, a re-
placement can be obtained from
your Miele dealer or the Miele Spare
Parts dept.
63