Intergraph Intense 3D Voodoo Installation Manual page 18

14
3. Click OK. The Copying Files dialog displays.
4. Click Browse, and then click OK. The Copy Files dialog displays.
5. Click OK.
6. When prompted to restart the computer, click Yes.
NOTE If the Intense 3D Voodoo driver does not start, use the correct
procedure to shut down and turn power off to your computer.
Then turn power on to your computer.
7. Allow the system to restart, and then log on to Windows 95.
NOTE The Intergraph Video Center (also known as TV Out Utilities) is
automatically installed during the Intense 3D Voodoo Windows 95
driver installation. You may also choose to install the DirectX
application. For information, see "Installing the Application
Programs" in this chapter.
Reinstalling the Intense 3D Voodoo Driver (Windows
95)
Use the instructions in this section if you need to reinstall the Intense
3D Voodoo driver on a computer running Windows 95, or if Windows
95 did not correctly detect new hardware after you installed the Intense
3D Voodoo card.
NOTE Use these instructions only if your computer is running Windows
95. The reinstallation instructions for Windows 95 are different
from the initial installation instructions described previously. If
your computer is running Windows NT 4.0, reinstall the driver
using the Windows NT 4.0 instructions in "Install the Intense 3D
Voodoo Driver" in this chapter.
To reinstall the Intense 3D Voodoo device driver:
1. From the Start menu, go to Settings/Control
Panel/Display/Settings (tab).
2. Do one of the following:
If you are using the commercially-available release of
Windows 95, click Change Display Type. The Change
Display Type dialog displays.
If you are using Windows 95 OEM Service Release 2, click
Advanced Properties. The Advanced Display Properties
dialog displays.