Setting Up And Connecting Nettool; Introduction; Configuring Nettool - Fluke Network Tester User Manual

Introduction

This chapter shows you how to set up NetTool. Among
the tasks covered are how to set NetTool's date and time,
how to configure its IP address information, and how to
locate important information, such as the serial number.
This chapter also shows you how to make a single-ended
connection and an inline connection between NetTool
and a network device.

Setting Up and Connecting NetTool

Configuring NetTool

To configure NetTool, select the NetTool icon
The NetTool menu is displayed:
Use this menu to access the tester's setup menus, which
are described in the following sections.
Chapter 2
Figure 2-1. NetTool Menu
.
afq59s.bmp
2-1