New Balance 7.0r Owner's Manual page 7

STEP 1 – Foot Tube Assembly
Remove the two Carriage Bolts, Washers and Nylon
Nuts from both the Front Foot Tube with Rollers and
the Rear Foot Tube with Caps.
Align the Rear Foot Tube with the rear of the Main
Frame Assembly. Make sure the square holes in the
Rear Foot Tube are on the outside. Insert Bolt
through the Foot Tube and Main Frame Assembly.
Secure with Washers and Nuts you just removed.
Tighten with the Wrench
provided.
Repeat on the front of
the unit using the Front
Foot Tube with Rollers.
STEP 2 – Back Rest and Seat
Cushion Assembly
a) Place the Seat Carriage Slider on the
Back Rest with the Seat Carriage
Bushing toward the top of the Back
Rest. Secure with the Phillips Bolts,
Washers and Hex Nuts from your
Fastener Pack. Tighten Bolts with
the Wrench provided.
b) Place the Seat Cushion on a flat surface. Position the Seat
Carriage with the Wheels up as shown. Secure with Phillips
Bolts and Washers. Tighten with the Wrench provided.
Turn Assembly over.
c) Remove the Bolts, Washers and Nuts with Nut Caps
from the Rear Handlebar (the ones with the Pulse Sensors).
Position the Rear Handlebar into the notch on the Seat
Carriage, making sure the wires are facing down and the
Pulse Sensors are facing up. Replace the Bolts, Washers and
Nuts with Nut Caps you just removed. Tighten with
the Wrench provided.
d) Slide the Back Rest onto
the Seat Carriage
until it clicks into an
adjustment hole.
Make sure the
wider part of the
Back Rest is toward
the Seat Cushion.
Tighten the Seat
Adjustment Knob.
6
front of unit
main frame
assembly
2c
pulse sensor
replace bolts,
washers and
nuts with nut caps
seat cushion
rear
handlebar
1
replace bolt from
bottom side up
into square holes on rear foot tube
rear of unit
top of back rest
seat carriage bushing
goes towards top of seat
M6 x 30mm phillips bolts
seat carriage slider
2a
seat
carriage
locking
knob
seat
carriage
locking
knob
seat cushion
seat carriage
wires
rear of unit
replace washer replace washer
and nut from top side and nut from top side
rear foot tube
assembly shown
(no roller on
rear foot tube)
M6 washers
M6 hex nuts
M6 x 15mm phillips bolts
M6 washers
2b
underside of
seat cushion
back
rest
seat
adjustment
knob
seat
carriage
2d
seat
carriage