Replacing The Color Wheel - Sharp Conference Series XG-PH80W-N Operation Manual

Replacing the Color Wheel

The projector is equipped with a four-segment color wheel. You can replace it with a
six-segment color wheel (sold separately). The replacement procedure described
below also applies when you put the four-segment color wheel back in the place of
the six-segment one.
Warning!
• Do not remove the color wheel from the
projector right after use. The lamp and parts
around the lamp will be very hot and may
cause burns or injury.
1 1
Press STANDBY/ON on the
projector or on the remote
control to put the projector into
Standby mode.
2 2
Switch the MAIN POWER switch
on the projector to "OFF" and
then disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3 3
Remove the lamp unit cover.
• Loosen the user service screw (1) that
secures the lamp unit cover. Remove the
lamp unit cover (2).
STANDBY/ON button STANDBY/ON button
MAIN POWER switch MAIN POWER switch
AC socket AC socket
User service screw User service screw
(for lamp unit cover) (for lamp unit cover)
69