Setup Menu; Recording; Settings Concerning Normal Recording And Alarm Recording; Pre-Alarm Recording - Mitsubishi Electric DX-TL5000E Installer Manual

Recording

Settings concerning normal recording and
alarm recording
This unit allows you to set the setting items for normal
recording and alarm recording individually. It means, more
detailed settings are possible, such as changing the recording
rate of the camera of which the alarm signal is input while
leaving the normal recording settings as they are.
• The recording and playback cannot be performed
properly when the clock of this unit does not run. Check
that the clock of this unit is running before operation.
• The settings cannot be changed during normal
recording and alarm recording. Change the setting
after stopping recording. To pause the sensor input
(up to 5 minutes), set the "Alarm Input" in the
<Recording> menu to "Off."
• When setting the camera number of which the camera
is not connected in the <Set Recording Pattern A
(Normal/Timer)> to <Set Recording Pattern D (Timer)>,
the warning display appears when recording pictures
( see "Warnings and CALL OUT output" on pages
114 and 115).
To activate normal recording and alarm recording, set the
following items:
• Recording rate and picture grade for normal recording
and alarm recording
(<Normal Recording Menu> and <Alarm Recording
Menu>)
• The camera selection during alarm recording
("Alarm Mode" in <Alarm Recording Menu>)
• Whether to execute pre-alarm recording
("Pre-Alarm Duration" in <Alarm Recording Menu>)
• The recording camera and trigger for alarm recording
(<Alarm Camera Setting> and <Alarm Trigger In/Out>)

Pre-alarm recording

Pre-alarm recording is a function to start recording a few
seconds before the ALARM IN terminal on the rear panel
is grounded, motion is detected, or the alarm signal is input
via LAN or RS-232C communication.
disturbance
Time
Camera input
Recording process
1) The PRE-ALARM indicator illuminates during pre-alarm
recording and during stand-by mode.
2) Starts recording before the ALARM IN terminal is
grounded or motion is detected.
3) Executes only when pre-alarm recording is set in the
<Alarm Recording Menu>. After the input of an alarm
signal, only the cameras set in the alarm recording
setting are used for recording.
• When a pre-alarm recording starts during normal
recording, it may be executed for a different time
period from the alarm setting.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Operations
Alarm input
Records data on HDD before alarm is input.
Set Recording Pattern A (Normal/Timer) to
D (Timer)
This item is used to make the recording settings for normal
and alarm recordings.

Setup Menu

1 Recording
Set Recording Pattern A (Normal/Timer)
1 to 4
to D (Timer)
1 Camera Check
2 + D Recording Setting A to D-Normal (Auto)
D Recording Setting A to D-Normal
2 + D Recording Setting A to D-Normal (Easy)
D Recording Setting A to D-Normal
2 + D Recording Setting A to D-Normal (Manual)
D
Recording Setting A to D-Normal
3 Alarm Recording Menu
1 + D Recording Setting A to D-Alarm (Easy)
D Recording Setting A to D-Alarm
Recording Setting A to D-Alarm (Manual)
1 + D
D
Recording Setting A to D-Alarm
Alarm Camera Setting
4
D Alarm Camera Setting A to D 1-8
D
Alarm Camera Setting A to D 9-16
Alarm Trigger In/Out
5
D
Alarm Trigger Setting A to D
Alarm Input
6
Setup Menu
1
step
2 to 6
steps
2
step
7
step
7, 8
steps
51