Search By Alarm List; Basic Operations - Mitsubishi Electric DX-TL5000E Installer Manual

Basic operations (continued)

Search by Alarm List

This unit stores the start time of alarm recording and emer-
gency recording in the alarm list when such recording be-
gins. This item is used to search the desired picture using
the list of alarm recording (emergency recording). The
search result displays in still frame playback of the single
screen display.
User Menu
1 Search
Search by Alarm List
3
Alarm List
D
1. Set the date, month, year, hour, minute, second, and
step
sensor number to be searched.
Latest: Displays the date and time of the latest
recording.
2. Select "Alarm List."
step
• The alarm list may take longer time to display
completely when there are many items in the list or
when a HDD has been added.
• The displayed alarm list shows the list of alarm
recordings which has been started before and closest
to the specified time.
3. Select the alarm list you want to display.
step
• To change the source device to be searched, set the
desired device in the <Select Source Device> (User
Menu Search Select Source Device). (
42.)
To execute alarm list search while the "Alarm area"
and "Long pre-alarm area" are set, set the playback
area to "Alarm" and "LPA" respectively.
• "Sensor" display indicates the sensor number of which
the alarm signal is input.
• When "Repeat of Normal Recording Area" or "Repeat
of Alarm Recording Area" (System Menu
Data Management Setting for Main Memory) is set
to "Repeat Off" and there is an alarm recording
(emergency recording) at the end of the HDD, that
recording may not be stored in the alarm list and that
item may be missed.
• When the data of the camera number which is not
corresponded to the alarm sensor number is copied
to the external media, the alarm list of that data is not
exactly similar to that of listed in the digital recorder.
• When the detection of the motion or the ground of
the ALARM IN terminal occurs numerously at the
same time, not all the start times of the alarm recording
may be registered in the alarm list. In this case, the
sensor of the lowest number is registered in the list.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Basic operations
100
• In the alarm list, items with the ALARM IN terminal
grounded are indicated in orange, items that were
detected with motion are indicated in white, items with
the EMERGENCY terminal grounded are indicated
in magenta, and items that were input with alarm
signal via communication are indicated in green.
• To clear the alarm list, erase the HDD data of which
the alarm recording is recorded (System Menu Data
Clear). Beware that executing it erases all the data of
the HDD contained the picture data.
• Alarm list search is not performed if there are no index
signals.
1, 2
steps
• When alarm recording (emergency recording) is
started while displaying the <Alarm List>, you must
3
step
first exit the <Alarm List> and then display it again.
The new item will be added to the list. In this case,
you may have to specify the date and time to be
searched again.
• For alarm list search of LPA area, the list from the
start point of media is displayed when selecting "To
latest," and the list from the end point of media is
displayed when selecting " To oldest."
See page
Memory