Major Operations And Their Functions; Front View - Mitsubishi Electric DX-TL950E Installation And Operation Manual

Major operations and their functions

Front View

1 2
ACCESS
POWER
1. POWER button
When pressing this button while the MAIN switch on
the rear of this unit is set to ON, the power turns on
and the button lights. When the button is pressed
again, the unit will be in stand-by and the light will
turn off. When the unit is in operational transition
such as booting, the button will flash and other op-
erations are not accepted.
2. ACCESS indicator
Illuminates during access to hard disk drive or Com-
pact Flash Card.
3. Camera number buttons (1 to 9)
Press the button to display the image from the cam-
era connected to this input on to the monitor.
4. TIMER button
When pressing this button, the unit is set to timer
recording/stand-by and the TIMER button lights.
When pressing this button for more than 1 second,
timer recording/stand-by is cancelled and the TIMER
button turns off.
5. REC/STOP button
When pressing this button, recording starts and the
button lights. When pressing the button for more than
1 second, the recording stops and the light turns off.
When pressing this button for more than 1 second
during alarm recording, recording stops. During timer
recording, recording will not stop even if the button
is pressed.
6. SHUTTLE ring
Used to set various menus and search functions,
adjusting the playback speed, and rewinding or for-
warding the recording images.
7. JOG dial
Used to set various menus and search functions,
forwarding or rewinding the image during playback
(field-by-field).
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
10
3
1 2 3 4 5
SPLIT/
ZOOM / 0
SEQUENCE
OUTPUT B COM
OUTPUT
A/B
Digital
DIGITAL RECORDER DX - TL950
8 9 10 11
6 7 8 9
PRE ALARM M-DET
EMERGENCY LOCK
Multplex
Record
&
12 13 14 15 16
8. SPLIT/SEQUENCE button
Press the button to display SPLIT9, SPLIT4 screen
or SEQUENCE screen setting on multiplexer
functions.
9. ZOOM button
When pressing this button once during single screen
display, the screen is magnified by 100%. In the same
way, pressing the button twice magnifies the screen
by 200% and pressing the button three times magni-
fies the screen by 400%. The magnification center point
(X) is displayed in the center of the screen in screen
display 1. Press the camera number buttons (1, 2, 3,
4) to move the magnification location. When the ZOOM
button is kept pressed for one second or longer, the
operation of the camera number buttons and the SPLIT/
SEQUENCE button is switched between operation for
OUTPUT A (screen of the monitor connected to the
OUTPUT A connector and the VIDEO OUT connec-
tor) and operation for OUTPUT B (screen of the monitor
connected to the OUTPUT B connector).
To display image of the monitor connected to OUT-
PUT B, set to "ON" in the setting of the "OUTPUT B
ON/OFF" of the <MPX DISPLAY SETTINGS> screen.
see page 37.
10. OUTPUT B indicator
This is not lit when the operation of the camera
number buttons and the SPLIT/SEQUENCE button
is set to OUTPUT A, and it lights with switching to
OUTPUT B.
11. COM (COMMUNICATION) indicator
Illuminates when establishing the communication with
personal computer.
12. PRE ALARM indicator
Illuminates during pre-alarm recording mode.
13. M-DET indicator
Illuminates when the motion detection function is on.
4 5 6 7
REC/STOP
CLEAR/
REW
TIMER
ENTER/
FF