Initial Settings; Initialization; Hdd Setting - Mitsubishi Electric DX-TL950E Installation And Operation Manual

AUTO SET UP
The <RECORD SETTING> screen consists of 2
pages. The second page is displayed when turning the
JOG dial to move the cursor to "NEXT PAGE", and turn
the SHUTTLE ring clockwise.
<RECORD SETTING> 1/2
Camera selection during alarm recording
<RECORD SETTING>
NO PPS
>> 1 12.5P
2
------ SUPER ------ SUPER
3
------ SUPER ------ SUPER
4
12.5P
5
------ SUPER ------ SUPER
<ESTD REC>
NEXT PAGE
<RECORD SETTING> 2/2
<RECORD SETTING>
NO PPS
>> 6 ------ SUPER ------ SUPER
7
12.5P
8
------ SUPER ------ SUPER
9
------ SUPER ------ SUPER
<ESTD REC>
PRESS POWER BUTTON TO EXIT
According to the number of the cameras connected
and the value of "RECORDING CYCLE", the most suit-
able setting of the "PPS", "A-PPS", "GRADE" and "A-
GRADE" are set automatically.
12. When the setting is complete, press the POWER button.
• "SETTING UP..." is displayed on the screen, and the unit
starts-up.
To execute AUTO SET UP again, press and hold
the camera number button 1 and press the POWER
button, when the MAIN switch is set to ON and the
POWER button is set to OFF. The <CAMERA CHECK>
screen appears. However all menu of record setting
will be reset.

INITIALIZATION

The <INITIALIZATION> setting is used to select the mode of
peripheral recording devices connected to SCSI connector
ID4 ID5, to make HDD SETTING, and to initialize the HDD.
•

HDD SETTING

The HDD SETTING can be set to MIRRORING (simulta-
neous recording to the internal HDD as a pair), PARTITION
(an independent partition that can be set within the total
HDD memory specifically for ALARM RECORDING). (
see pages 74,75 "MIRRORING", "PARTITION")
<INITIALIZATION>
>>HDD SETTING
POWER OFF
INITIALIZATION
ALL DATA WILL BE ERASED
WHEN PROCEED INITIALIZATION
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• AUTO SET UP / Initial settings
18

/ Initial settings

(continued)
ALARM CH
GRADE A-PPS A-GRADE
SUPER 12.5P SUPER
SUPER 12.5P SUPER
D H M
GRADE A-PPS A-GRADE
SUPER 12.5P SUPER
D H M
NORMAL
INITIALIZATION
Please perform initialization, when a <INITIALIZATION>
setup is changed.
1. Turn ON the MAIN switch on the rear of the unit, and wait
until the ACCESS indicator goes off. Hold down the REC/STOP
button, and press the POWER button on the front of the unit.
• The unit starts-up, and the <INITIALIZATION> screen is
appears.
POWER button operation will not be accepted while
the ACCESS indicator is flashing. Press the POWER
button after the indicator turns off.
2. Select "INITIALIZATION" by turning the JOG dial, and turn
the SHUTTLE ring clockwise.
• The setting is made, and the display returns to normal after
initialization.
Settings are not confirmed unless you perform
"INITIALIZATION".
Performing "INITIALIZATION" initializes all data on
the HDD. It deletes the complete ALARM LIST, and
the next entry is registered from 00001.
Select "POWER OFF" to abort initialization.