5
INSTALLATION OF PAPER
Moisture, fi ngerprints or dust on
the paper surface may cause a
noise at printing or deterioration
in print quality. Set the paper by
the following procedure to prevent
adhesion of fi ngerprint or dust on
the paper surface.
Open the door.
Load the paper roll.
INCORRECT
CORRECT
Note:
The printing surface is the outside.
Place the paper with the thermsen-
sitive side (printing side) up.
When the paper roll is placed in-
versely, images can not be printed.
Press the OPEN
•
button.
The door opens.
• Place the paper roll
in the printer.
printing side
Pull out the paper end.
Close the door.
Cut the paper end.
Cut the paper end with the cutter by
•
pulling the paper upwards against the
cutter blade.
9
• Pull out the fi rst 15-
20cm (6 in. - 9 in.)
of the paper to
remove any slack
in the roll.
cutter