If you have already loaded media contents into the player, contents will play back immediately after boot up, and
the "Copying from USB drive" screen will not be shown. You can still plug in a USB keyboard at any time during
playback to enter the menu system.
2.2. USB keyboard Configuration Menus
You must attach a USB keyboard to the XMP‐300 to configure the media player. With the player booted up and
ready, it takes approximately 30 seconds after you plug in the keyboard for the following menu to be displayed:
1
Navigating the menus
Navigate the menus using arrow keys, space bar, enter key, and numeral keys on your USB keyboard. Use the
keyboard arrow keys to highlight menu items, press the space bar to move the star (cursor), and then press enter
to confirm (<OK>) or reject (<Cancel>) any changes.
NOTE: If you plan to use your XMP‐300 as a standalone media player without a connection to your network,
please proceed to Section 2.3 to complete configuration.
2.3. Connect the XMP300 to your network
Attach a LAN cable (RJ‐45) to your XMP‐300 media player.
If you plan to attach the XMP‐300 to your network, you will need to assign an IP address from your network. This
is accomplished by two possible ways:
1) DHCP – Automatically Assign Network IP Address
Highlight "Network setting" and press
"Enter" on the keyboard to select.
vii