Inserting And Removing The Battery Pack - Sharp VIEWCAM VL-SD20S Operation Manual

Preparation
Preparation
Inserting and Removing the
Battery Pack
Inserting the Battery Pack
1
Make sure that the Power switch is set
to OFF.
2
With the lens facing up, slide the battery
compartment door release to OPEN
(Q), and open the battery compartment
door (W).
Battery
compartment
door release
3
Insert the battery pack into the com-
partment with the ∂ mark facing up, and
push it in completely until it locks into
place.
∂ mark
V L - S D 2 0 S - G B / p p . 0 0 8 - 0 1 6 ; 9 9 / 8 / 1 0 / 1 8 : 0 0
4
Firmly press the door closed (Q), and
slide the release to CLOSE (W).
Removing the Battery Pack
1
Perform steps 1 and 2 above.
Power switch
2
Press the battery release as shown (Q),
and remove the battery pack (W).
Battery
release
Cautions:
• BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP THE TAPE AND TURN THE
POWER OFF. If you remove the battery pack
during recording or playback, the tape will
remain wound around the video head drum,
potentially causing damage to the tape.
• Make sure the battery compartment door is
closed firmly during operation. If it is not, the
battery pack may fall out or VIEWCAM operation
may fail because of the poor contact pressure.
• Remove the battery pack from the VIEWCAM if
the VIEWCAM will not be used for a long period
of time.
• When removing the battery pack, do not tilt the
VIEWCAM so that the battery compartment faces
down. The battery pack may fall out.
• Do not expose the battery compartment door to
strong force, as it may come off.
• Use only SHARP model BT-L241 or BT-L441
battery packs with this VIEWCAM. Use of other
batteries may present a risk of fire or explosion.
G. K . A s s o c i a t e s , To k y o
8