Wipe - Sharp VIEWCAM VL-SD20S Operation Manual

Wipe

The wipe function can be used to create an
interesting presentation of playback images in
which a still image is replaced with the next
image appearing in the middle of the screen.
Preparation
1
Plan the scene transition, and record still
images with the still recording function
(see page 36).
Notes:
• The wipe function can also be used to
provide a transition from a still image to a
moving image.
• Record images for 6 seconds or longer. An
image recorded for less than 6 seconds
may not dissolve properly.
2
Rewind the tape to just before the
position you want to playback.
Using Wipe
1
In VCR mode, display the menu screen
(see page 25).
2
Toggle the CONTROL switch (Q) to
select "PB EFFECT", then press the
CONTROL switch (W) to select "WIPE".
- - - - - - - - - - - - - - - - - - - - - - - -
D I SP L AY
AUD I O
T C OUT
P B E F F E C T
REMOT E
3
Press the EXIT button (MODE DISPLAY)
to turn off the menu screen, then press
the MODE DISPLAY button to turn off
the mode screen.
V L - S D 2 0 S - G B / p p . 0 5 9 - 0 6 3 ; 9 9 / 7 / 2 / 1 8 : 0 0
4
Press the
• The still image is replaced with the next
image appearing in the middle of the
screen.
To cancel Wipe mode
Press the CONTROL switch to set the PB
EFFECT menu item to "OFF" in step 2 above.
Note:
• Wipe mode will be cancelled if the Playback
Zoom, Multiple Strobe Playback or Picture
Effect Playback is used thereafter.
ME NU
O F F
A UD I O 1 + 2
O F F
W I P E
ON
SE T E X I T
G. K . A s s o c i a t e s , To k y o
button to begin playback.
62