Table of Contents
Advertisement
Inserting
and Removing
the
Battery
Pack
iiiiiiiiiiii ii ii!ii!!i i!i!ii!ii!!i!!i!!!!iiii!iiiiiiii ii
iiiiiiiii ii iii ii,li ii!i !! ii i!!i!ii!ii!ii!ii !i!i i!i!i
Inserting
the Battery
Pack
1
Make sure that the Power switch is set
to OFR
4
Close the door, pressing
it firmly in the
center until it clicks,
2
Power switch
Slide the battery compartment
door
release on the bottom of the VIEWCAM
in the direction
of the arrow to open the
battery compartment
door.
ttery
I
_il
I compartment
door release
}nsert the battery pack into the com-
partment
as shown, and push it in com-
pletely until it locks into place.
Caution:
• Do not force the battery pack into the
battery compartment if it does not go in
easily.
Removing
the Battery
Pack
1
Perform steps 1 and 2 above.
2
Press the battery release as shown to
remove the battery pack.
,_
Battery
release
Cautions:
• BEFORE
REMOVING
THE BATTERY
PACK,
ALWAYS
STOP THE TAPE AND TURN THE
POWER
OFF. If you remove the battery
pack
during
recording
or playback,
the tape will
remain wound
around
the video
head drum,
potentially
causing
damage
to the tape.
• Make
sure the battery
compartment
door is
closed
firmly
during
operation.
If it is not, the
battery
pack may fall out or VlEWCAM
operation
may fail because
of the poor contact
pressure.
• Remove
the battery
pack
from the VIEWCAM
if
the VlEWCAM
will not be used for a long period
of time.
• When
removing
the battery
pack, do not tilt
the VlEWCAM
so that the battery
compart-
ment faces
down.The
battery
pack
may fall
out.
• Do not expose
the battery
compartment
door to
strong force,
as it may come
off.
• Use only SHARP
model
BT-H22 or BT-H32
battery
packs
with this VIEWCAM.
Use of other
batteries
may present
a risk of fire or explosion.
Advertisement
Table of Contents
