Inserting And Removing The Battery Pack - Sharp ViewCam VL-E89E Operation Manual

Inserting and Removing the
Battery Pack
Inserting the Battery Pack
1
2
3
Slide the battery compartment door
release on the bottom of the VIEWCAM
in the direction of the arrow (x), to open
the battery compartment door (2 ).
Insert the battery pack into the com-
partment with its bottom facing the
battery compartment door (IQ), and
push it in completely until it locks into
place @).
Caution:
l
Do not force the battery pack into the
battery compartment if it does not go in
easily.
0
Mode label
Close the door, pressing it firmly in the
centre until it clicks.
Removing the Battery Pack
1
Perform step 1 in the above procedure.
2 With the VIEWCAM facing down, press
the battery release as shown (j), and
remove the battery pack
( p).
0 1
a@
Cautions:
BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP THE TAPE AND TURN THE
POWER OFF. If you remove the battery pack
during recording or playback, the tape will
remain wound around the video head drum and
may be damaged. Should the power source
(battery or adapter) become disconnected
during operation, reconnect it again immediately.
Do not expose the battery compartment door to
strong force, as it may come off.
Make sure the battery compartment door is
closed firmly during operations. If it is not, the
battery pack may come off or VIEWCAM
operation may fail because of the poor contact
pressure.
Remove the battery pack from the VIEWCAM or
disconnect the VIEWCAM from the AC adapter if
the VIEWCAM will not be used for a long time.
When removing the battery pack, do not tilt the
VIEWCAM so that the battery compartment faces
down. The battery pack may fall out.
Battery Pack Handling
l
Make sure that you take enough battery
packs with you to provide two
to
three times
your estimated recording time. See page
11.
l
Recording time will be reduced in cold
weather.
l
The battery will drain in Recording Standby
mode. Turn off the power if you will not be
recording again soon.