Changing The Line Type - Savin 1027 Facsimile Reference Manual

RusC2FaxADEN-F_V4_FM.book Page 55 Monday, August 20, 2001 10:52 AM

Changing the Line Type

The optional ISDN Unit or Extra G3 Interface Unit is required.
When the optional ISDN Unit and Ex-
tra G3 Interface Unit are installed,
you can connect to up to a maximum
of 3 lines.
Limitation
❒ When sending a fax, you can select
the line type if dialing with the
number keys or Chain Dial.
Note
❒ When you install the optional
ISDN Unit or Extra G3 Interface
Unit, you can specify the line type
home position from "Gen. Set-
tings/Adjust". ⇒ p.125 "General
Setting/Adjustment"
❖ ❖ ❖ ❖ G3
If you install Extra G3 Interface
Unit, you can select "G3-1" or "G3-
2" depending on the number of the
installed unit.
Changing the Line Type
❖ ❖ ❖ ❖ G4
ISDN line is selected.
Limitation
❒ If you select the G4 mode, JBIG
compression is not available.
❖ ❖ ❖ ❖ Which line is used for G3 transmis-
sions?
ISDN lines can be used for G3 com-
munication as well as G4 commu-
n i c a t i o n . I f t h e m a c h i n e i s
connected with an ISDN and ana-
log (PSTN) line, each line can be
available by selecting "G3 Auto".
Select "I-G3" when you use the
ISDN line for a G3 transmission.
Note
❒ When you use G3 with ISDN,
you can set the sub-address and
UUI.
4
55