Sep Code - Savin 1027 Facsimile Reference Manual

RusC2FaxADEN-F_V4_FM.book Page 45 Monday, August 20, 2001 10:52 AM

SEP Code

Normally you can only use Polling Re-
ception (⇒ p.12 "Polling Recep-
tion")to receive faxes with ID from
machines that have the Polling Recep-
tion feature of the same make. Howev-
er, if a machine of another make
supports polling reception, you can re-
ceive fax messages with ID from that
machine using this method instead.
Poll the other machine. You can re-
ceive messages that have the same
SEP code as the SEP code you enterd.
Limitation
❒ You can only use this feature with
a G3 or I-G3 line (not with G4).
❒ You cannot use Chain Dial with
this feature.⇒ p.41 "Chain Dial"
Note
❒ The ID can be up to 20 digits long.
❒ Make sure the number of digits in
the ID matches the specification of
the machine to which you are
sending.
❒ You can store not only destination
names and fax numbers but also
SEP Codes in Quick Dials, Groups
and Programs. Digits, spaces, *
and # can be stored.⇒Chapter 3,
"Quick Dials" in the Basic Features
manual, Chapter 3, "Groups" in the
Basic Features manual,⇒ p.97
"Registering Keystroke Programs"
❒ Messages you receive using this
feature are marked "SEP" on all re-
ports.⇒ p.124 "Reports/Lists"
A A A A
Dial the fax number using the
number keys.
B B B B
Press [Adv. Features].
The advanced features menu is
shown.
C C C C
Select [SEP Code].
D D D D
Press [RX SEP Code].
E E E E
Enter a SEP Code with the
number keys.
If you make a mistake, press the
{ { { { Clear/Stop} } } } or [Clear] and try
again.
Advanced Features
4
45