Multiple Operation - REVELL Performa B15 Owner's Manual

Figure 12. How to connect
multiple REVEL PERFORMA
B15 subwoofers.
Multi-Channel Controller (Decoder)
(rear)
FRONT/MAIN
Left Output CENTER Output
Right Output SUB/LFE Output
NOTE: Set Controller outputs to full-range L/R Front and no SUB.
If applicable, set all other channels to pass 80 Hz and above.
Below 80 Hz, signals will route to the B15s. Alternately, if Controller's
crossover is used (i.e., SUB/LFE Output) set Low Pass Filter to
or
OFF on all B15s.
or
RCA cables
to #1 B15
AUX OUTPUT
REVEL PERFORMA B15 SUBWOOFERS IN

MULTIPLE OPERATION

Multiple REVEL PERFORMA B15 subwoofers (using their own
crossovers) can be connected in a "daisy-chain" with a multi-channel
controller and power amplifier, as shown in Figure 12. If all sub-
woofers are placed next to each other or in symmetrical room loca-
tions, set all level and phase controls for the same respective values.
SURROUND/SIDE REAR
Left Output Left Output
Right Output Right Output
#2 B15 Rear Panel
(split view)
(Optional)
XLR cables
to #3 B15
INPUT
or or
RCA cables
to #3 B15
INPUT
Left Input
Main Amplifier
(rear)
Left
To Main Speakers
or
#1 B15 Rear Panel
(split view)
or
RCA cables
to #2 B15
INPUT
REVEL PERFORMA B15
Right Input
Right
or
19
Owner's Manual