This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Revel Concerta B120 Owner’s Manual...
Since 1996, the Revel brand has been at the forefront of loudspeaker design. Backed by Harman International’s extensive research and design facilities, Revel Concerta...
B120 Equalization controls for fine-tune adjustments. To help determine good locations for the subwoofer(s) and the listener(s), it is recommended that you make high-resolution in-room response measurements. Your authorized Revel dealer can make the appropriate measurements, using suitable equipment to ensure optimal results. Note...
Generally, it’s best to place the Revel Concerta B120 subwoofer(s) near solid walls to reinforce bass response. Avoid placing the subwoofer(s) near windows, which can rattle and transmit sound to the outside world.
Page 6
Figure 5. Your authorized Revel dealer can use in-room measurements to fine-tune the locations, accounting for variation in construction among the room walls.
Review the owner’s manuals for associated audio components to determine their connection requirements. The B120 subwoofer input connectors are located on the rear panel. Two gold-plated RCA connector options are available – Sub In Low-Pass Disabled (Normal) and L/R Low-Pass Enabled –...
Page 8
RCA Y-adapter and possibly an additional single-RCA cable. 1. Connect an RCA patch cable from the Subwoofer or LFE output on the processor/receiver to the single input on the Y-adapter, as shown in Figure 11.
Page 9
Subwoofer or LFE output connector. 1. Set the processor or receiver to “Mono Subwoofer.” 2. Connect the supplied RCA patch cable from one of the Subwoofer or LFE outputs on the processor/receiver to the Sub In connector on the B120 rear panel, as shown in Figure 12.
Figure 14: Rear-panel controls and connectors SUBWOOFER OPERATION The rear panel of the Concerta B120 subwoofer, shown in Figure 14, contains all of the available connectors and controls. The Input section of the rear panel was discussed in the “Making Connections” section, earlier in this manual.
50Hz and 100Hz, when using larger main loudspeakers that can comfortably reproduce some low-frequency sound. With a lower frequency setting, the B120 subwoofer concentrates on reproducing the deep bass required by contemporary music and film soundtracks. Set the...
Level, as shown in Figure 18. Note Specific measurement equipment is required to properly adjust the Equalization controls. Your authorized Revel dealer can make the appropriate measurements, using suitable equipment to ensure optimal results. Power Switch Connects or disconnects power from the AC input cord.
Page 13
TX1 transmitter and an electrical wall outlet. 3. Set the ID Code on the transmitter and subwoofer to the same position, as described in the “ID Codes” section. When the ID Code is properly set, the LED on the rear panel of the B120 subwoofer lights in orange.
1. The Revel products were purchased within the 50 United States, its territories, or Canada. 2. The dealer from whom the Revel products were purchased was authorized to sell such products at the time of the original purchase.
Power Requirements 120V AC @ 60Hz, 2A Height 17-3/4" (45.0cm), including feet Width 15-3/4" (40.0cm) Depth 14" (35.6cm) with grille Weight 51 lb (23.15kg) Features, specifications and appearance are subject to change without notice. NOTES Revel Concerta B120 Owner’s Manual...